25-44 Borough Place • Woodside, NY 11377 • 718.278.7900 • email:info@super-tek.com
  • Contact Us
  • MSDS Sheets
  • Trowel Selection Guide

    If you are reading this page on a standard VGA or Mac screen (72 dpi) the line drawings of trowels should appear approximately life size.

    Use This Trowel: For This Job:
    This is a picture of a v-notched trowel with 1/8 deep notches For setting Ceramic Mosaics, Slate, and other flat-backed tile on horizontal surfaces with adhesive.
    This is a picture of a trowel with v-shaped notches measuring 3/16 deep For setting Glazed Wall Tile and Ceramic Mosaics over horizontal and vertical surfaces with adhesive.
    This is a picture of a trowel with v-shaped notches 1/4 deep For setting Quarry, Slate, and Marble over horizontal surfaces with adhesive.
    This is a picture of a trowel with 1/8 square notches in it. For setting Glazed Wall Tile, Ceramic Mosaics, Slate and Marble over horizontal and vertical surfaces with thin-set, latex thin-set, or epoxy mortars.
    This is a picture of a trowel with 1/4 square notches in it For setting Floor Tile, Marble, Slate and Ceramic Mosaics over horizontal surfaces with thin-set, latex thin-set or epoxy mortars.
    The notches in this trowel are 1/4 wide and 3/16 deep For setting Quarry, Pavers, Stone and large floor tiles over horizontal surface with thin-set, latex thin-set, or epoxy mortars.


    Last Page Table of Contents Next Page



    All material at this site is © Copyright 2003 Super-Tek Products, Inc. and may not be reproduced without written permission.