25-44 Borough Place Woodside, NY 11377 718.278.7900 email:email@example.com
Super-Tek Products, Inc.
25-44 Borough Place, Woodside, NY 11377
Telephone #: 718-278-7900
Emergency Phone #: 718-278-7900
Generic ID: Latex Based Bonding Agent
Product Identity: Super-Weld
Date Prepared: 1/1/02
|Ingredient Name||CAS Number||Percent||Exposure Limits|
|Latex Polymer||N/A||26-28||5000 ppm (TLV)|
* Other Non-Hazardous Ingredients considered a Trade Secret
Initial Boiling Point: 220°F.
Vapor Pressure: Same as water.
Vapor Density (Air=1.0): Same as water.
Specific Gravity: 1.08-1.11.
Percent Volatiles: 70-72.0%.
Flash Point: 290°F.
Explosive Limit (Product): N/A.
Extinguishing Media: None to avoid.
SPECIAL FIRE FIGHTING PROCEDURES: None.
UNUSUAL FIRE & EXPLOSION HAZARDS: None.
Permissible Exposure Level: N/A.
Threshold Limit Value: N/A.
EFFECTS OF EXPOSURE:
Skin: Possible mild irritation.
Eyes: Possible mild irritation.
Inhalation: None known.
Skin: Soap and water.
Eyes: Flush with water, lifting upper and lower lids occasionally.
Inhalation: If affected, remove individual to fresh air. Use only in well ventilated areas.
Ingestion: Do not induce vomiting. Call physician or transport to an emergency facility.
Hazardous Decomposition: None.
Hazardous Polymerization: None.
Conditions to Avoid: None Known.
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Absorb liquid on paper, vermiculite, floor absorbent, or other absorbent material. Solidified materials accepted for landfill disposal in most locations. Check all local, state, and federal regulations.
Ventilation: Open all available windows and entrances to insure
Respirator Protection: None needed.
Protective Gloves: If sensitive.
Eye protection: Wear glasses or protective goggles to avoid splashes.
Other Protective Equipment: None required.
WASH HANDS THOROUGHLY WITH SOAP AND WATER.
Protect from freezing. Use only in applications as stated on the label. Do not take internally. Close container after each use. Avoid skin and eye contact.
Ventilation with fresh air, including open doors and windows should be observed during any flooring installation. Operate HVAC systems at 100% fresh air intake before, during and after installation to eliminate lingering odors or particulate matter.
The information accumulated herein is believed to be accurate but is not warranted to be whether originating with company or not. Recipients are advised to confirm in advance of need that the information is current, applicable and suitable to their circumstances.
KEEP OUT OF REACH OF CHILDREN